Sim card inserting/removing – 2N BRI Lite/Enterprise v1.4 User Manual
Page 19
19
overload). Remember that multiple GSM gateways used in one location may
overload the base transceiver station (BTS) you are currently logged in to. This
may lead to a permanent or occasional rejection of GSM/UMTS calls!
No strong electromagnetic radiation is allowed on the 2N BRI Enterprise /
®
installation site.
BRI Lite
No strong electromagnetic reflections are allowed on the 2N BRI Enterprise /
®
antenna installation site.
BRI Lite
An inappropriate location of
or its antenna
2N BRI Enterprise / BRI Lite
®
close to television, broadcasting and/or other rf–sensitive sets may impair the
function of these sets.
Being a source of radio frequency emissions, the 2N BRI Enterprise / BRI
®
antenna should not occur in the close vicinity of the human body. The health
Lite
hazard is higher than with mobile phones as, generally, gateways shared by
multiple users show a very high traffic.
It is recommended that the power supply adapter should be connected to a
network with a UPS back–up and due overvoltage protection.
SIM Card Inserting/Removing
Insert the SIM card in the
bottom as shown in the
2N BRI Enterprise / BRI Lite
®
figure. As the SIM slots are of the Push/Pull type, just slide the card in and push it into
position. Push the SIM gently to slide it out of the slot.
Caution
Be sure to
such provider/SIM card services as call forwarding, call
set
barring, preferred networks, SMS centre, etc. in your mobile phone
into
before inserting the SIM card
2N BRI Enterprise / BRI
®
.
Lite
If two SIM cards are used, make sure that both the SIM cards have
or
.
one and the same PIN
PIN code request disable
Having inserted the SIM card, restart 2N BRI Enterprise / BRI
®
to make the SIM card log in.
Lite
Remember to
the
service before using
disable
Another call on line
the SIM cards!