2N BRI Lite/Enterprise v1.4 - Manual (Page 103)

103
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Tracing Commands
AT!RE Start tracing of error messages active interface.
AT!Lx
Start tracing of LAN & Telnet on layer xx=2 – Layers IP,TCP,Telnet x=3 –
Layers TCP, Telnetx=4 – Layer Telnet
AT!Rx
Start tracing of ISDN BRI & GSM on layer xx=1 – Layers 1,2,3,4x=2 – Layers
2,3,4x=3 – Layers 3,4x=4 – Layer 4
AT!RR Start tracing (AT!R2) to COM1 interface
AT!RX Stop tracing (AT!R2) to COM1 interface
SMS Processing
SMS Sending/Receiving Commands
AT!G=A6
Start low–level controlling for SMS (can run only on
one port)
AT!G=55 Stop low–level controlling on used port
Control SMS
AT^SX=ch
…(sms listing) request to list all SMS messages and
status confirmations saved on SIM card. Possible
answers:: *smserr (busy,list) or *smsinc (ix=1..255)
for each saved SMS or status SMS messages, end of
list or empty SIM card – *smsinc (ix=0).
AT^SR=ch,ix
…(sms read) request to read SMS or status SMS saved
in SIM card. Possible answers: *smserr (busy,read) or
*smspdu
AT^SD=ch,ix
…(sms delete) request to delete SMS message (or
status SMS message). Possible answers: *smserr
(busy,delete) or *smsdel
AT^SM=ch,len,pdu,csum
…(sms to module) request to send message via GSM
module 0..31 or via any GSM module (ch=32). Possible
answers: *smserr (busy,write) or *smsout
AT^SG=grp,len,pdu,csum
…(sms to group) request to send SMS message via
GSM group 1..8. Possible answers: *smserr
(busy,write) or *smsout