2N EasyGate - User Manual User Manual

Page 25

Beep after dialing end

Function No.:

Select a beep to signal the end of dialing (beginning of outgoing call
establishing).

Setting options: YES/NO
Default setting: YES

BabyCall number

Function No.:

A number to be dialed for the automatic call function. If this item is blank, the
function is disabled.

Setting options: 0-15 characters (0-9,*,#,+)
Default setting: blank

BabyCall timeout [s]

Function No.:

Time between line Off-Hook and automatic call beginning (if enabled). During this
timeout EasyGate waits for dialing that cancels the automatic call. You can make
standard call if the BabyCall function is enabled.
Setting options: 0-15 s
Setting step:

1 s

Default setting: 0 s

Transmission volume

Function No.:

Volume setting for GSM transmission with a 4 dB step.
Setting options: 1-5
Setting step:

Default setting: 3 = medium volume level

Reception volume

Function No.:

Volume setting for GSM reception with a 4 dB step.

Setting options: 1-5
Setting step:

Default setting: 3 = medium volume level

CLIP

Function No.:

Set this item to enable/disable identification of a telephone line calling from a
GSM network. The function can be enabled if you have a device on your
telephone line that is capable of receiving FSK according to ETSI standards.
Setting options:

Disable

-EasyGate does not transmit the CLI.

FSK during ringing -EasyGate transmits the FSK-based CLI according to the

ETSI EN 300 659 standard (transmission during ringing).

Tbd.

- prepared for future use

Default setting: Do not transmit.

Replace character + in CLI by

Function No.:

If this parameter is filled, the + character in the international prefix of CLI is
replaced by the defined string. The + character can neither be transmitted by the
FSK protocol nor dialed by the DTMF from a terminal.

Setting options: 0-15 characters (0-9,*,#)
Default setting: blank