JLG 40RTS ANSI Service Manual - Manual (Page 48)

SECTION 2 - PROCEDURES
2-32
– JLG Sizzor – 3120691
17. Place other spacer onto smooth end of input shaft.
SAFETY GLASSES MUST BE WORN DURING THE FOLLOWING
STEP. BE AWARE THAT SPRING AND SPACERS, COMPRESSED
BY RETAINING RING, MAY POP SUDDENLY OFF SHAFT IF RING IS
RELEASED BEFORE IT IS PROPERLY IN PLACE.
18. Using retaining ring pliers, insert retaining ring into
groove on input shaft by compressing spring and
spacers together.
19. With large, splined end down, place input shaft
assembly into spindle.
20. Place thrust spacer onto input shaft.
21. With internal splines facing up (counterbore end fac-
ing down), place input gear into mesh with input
shaft sub-assembly.
22. Place thrust spacer on top of input gear.