Eppendorf New Brunswick Excella E-24 Shaker - Manual (Page 18)

Operation
New Brunswick
™ Excella ® E-24 Shaker
English (EN)
18
5.4 Timed functions
The shaker may be programmed to automatically stop after a preset time period of 0.1 to 99.9 hours. There
must be power to the shaker in order to set the timer, although a timed run can be initiated while the shaker
is either stopped or operating.
5.4.1 Setting the timer
To set the timer:
1. Press the SELECT key until the HRS indicator is illuminated.
2. Press either the or key to enter the SET mode and set the desired run time, between 0.1 and 99.9
hours.
3. Press the START/STOP key.
The shaker will stop and the display will read OFF.
4. Press the START/STOP key again.
The TIME indicator will light and the shaker will start the timed run.
5.4.2 If the shaker is stopped:
1. Follow steps 1 and 2, (see Setting the timer on p. 18)
2. Press the START/STOP key. The shaker will start in untimed mode.
3. Press the START/STOP key again. The shaker will stop and the display will read OFF.
4. Press the START/STOP key a third time; the TIME indicator will light and the shaker will start the timed
run.
If the shaker is stopped, (see If the shaker is stopped: on p. 18). If the shaker is already running
continue to Step 3.
To cancel the timer without stopping the shaker:
 Repeat steps 1 and 2.
 Immediately press the START/STOP key.
The TIME indicator will stop flashing and the display will read OFF.
To disable the visual alarm (flashing TIME indicator):
 Press the SELECT key and change to any other function