Rxqwhu )xqfwlrq %orfn – IKA labworldsoft User Manual

Page 52

- 52 -

&RXQWHU )XQFWLRQ %ORFN

The

&RXQWHU

function block can perform counting functions for input signals in the

TTL-Bereich

such as

SRVLWLYHQHJDWLYH VORSHV

2Q 2II WLPHV

The counter is automatically set to 0 at the start of a new measurement.

7KH IROORZLQJ FRXQWLQJ IXQFWLRQV DUH DYDLODEOH

&RXQW IXQFWLRQ

2XWSXW VLJQDO

Positive slopes:

Number of changes of the input signal from TTL-Low to TTL-High.

Negative slopes:

Number of changes of the input signal from TTL-High to TTL-Low.

Time High Level:

Seconds since the start of the measurement with a data value greater than

TTL-High (2.0) of the input signal.

Time Low Level:

Seconds since the start of the measurement with a data value less than TTL-

High (0.8) of the input signal.

Carry out the following instructions:

1. Call up the parameters window by double clicking on the icon.

2. If necessary, enter the

0RGXOH 1DPH

of the control block into the "Designation" text field.

3. Select

3RVLWLYH 1HJDWLYH 6ORSHV

function or

2Q 2II 7LPH

4. Confirm entries with

0XOWLFKDQQHO 2SHUDWLRQ

The ports should identifiable for multichannel operation. The ports may be identified for this

purpose.

Carry out the following instructions:

1. Set the

&KDQQHO &RXQW

by clicking the upper arrow keys.

2. Select the channel by clicking the lower arrow keys.

3. Enter the

&KDQQHO 'HVLJQDWLRQ

into the text field, i.e. make an entry for each channel

selected.

4. Select

3RVLWLYH 1HJDWLYH 6ORSHV

2Q 2II 7LPH

for the channel selected.