Advance Adapters 716138-N - Manual (Page 3)

ADVANCE ADAPTERS INC. P/N: 716138-N
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 3 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-28-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications
to any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will
be required to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction
sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained
for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts
stores.
JEEP 4.0L AUTOMATIC ADAPTER FLEX PLATE
SENSOR KIT 1997-2004
Extention loom wire colors
Orange = 5 volt supply
Gray = signal
Black with white tracer = ground If your stock harness plug does not match the new sensor plug provided in
this kit, you can splice the new loom into your stock harness. Refer to the
diagrams for pin and wire locations of your factory harness, and make some
notes for your reference. Cut the stock engine plug from the engine side on
the harness and solder the new loom provided in the kit to the wires you
marked. Note: the colors on our extension loom may not match the factory
harness colors.
DO NOT USE CRIMP CONNECTORS!