Advance Adapters 716073 - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 716073
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 2 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-12-10
1. After sensor hole has been drilled 2. The clamp on reluctor gets installed onto
the 700R output shaft and locked into
position. If a 4L60E shaft is to be used, a
different set collar in needed.
3. Reluctor ring installed
5. Tighten set collar of reluctor ring
to lock it to the main output shaft
7. Remove the bushing after test
fitting and then install the new
reluctor sensor.
4. Verify that the teeth of the reluctor
can be seen thruogh the new hole
6. Test fit the bushing into the trans-
mission housing. Make sure the
bushing fits snug to the outside of
the transmission. Note: You will
have a small gap on the top and
bottom side of this bushing, be-
tween it and the transmission.
4L60E TRANSMISSION
RELUCTOR KIT
Due to the different variations in 4L60E transmission case thicknesses you
maybe be required to modify part number 716073B (see photo A shaded
area) or your transmission case to obtain .010” - .012” gap (see photo B).