Advance Adapters 50-5040 - Manual (Page 5)

ADVANCE ADAPTERS INC. P/N: 50-5040
P.O. Box 247, 4320 Aerotech Center Way New Item: (06/05)
Paso Robles, CA 93447 PAGE 5 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-21-05
1310 NON CV VSS
TAILHOUSING RELUCTOR KIT
6. If wiring harness has correct plug installed, plug in the sensor now. If not, use the included pigtail to wire the sensor
into the wiring harness. The schematic below shows the correct description and color code for 1999 & newer sensor
provided in this kit. Please refer to the wiring diagram specific to your engine application for the correct circuit # and
computer pins to which the pigtail should be terminated. Also note that GM used twisted pair wire for this sensor
to eliminate any signal electrical interference.
7. Double check all set screws and bolts. Also check all the alignments of parts. Reinstall transfer case (if it has been
removed) and all other parts necessary to drive the vehicle. Use a scan tool to access the operational data and make
sure the correct signal is being read by the ECM.
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to
any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be
required to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet
is only to be used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained
for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts
stores.