Tx2 crawler adapter toyota 4wd trucks 21t input – Advance Adapters 50-5905D User Manual
Page 5

ADVANCE ADAPTERS INC.
P/N: 50-5905D
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 5 OF 9
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
08-10-09
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
(19) Remove the output shaft from
the front case by removing the
4 bolts with a 12mm socket.
Remove the bearing retainer
and snap ring.
(17) Remove the interlock
pin from the shifter
detent chamber, if you
haven't already done
so in Step 15.
(18) Use a 14mm socket to remove the 4 bolts that retain the
front case to the reduction case. Split the cases. Now you
can retrieve the roll pin that might have fallen in as noted
on Step 14.
(20) Remove the low range gear by removing the snap ring
that retains the roller bearing onto the rear shaft.
Press the roller bearing off of the shaft.
(21) Now that the roller bearing is removed, you will see
a spacer. Remove the spacer, the gear and needle
bearing.
TX2 CRAWLER ADAPTER
TOYOTA 4WD TRUCKS 21T INPUT