Advance Adapters 715543241 - Manual (Page 5)

ADVANCE ADAPTERS INC. P/N: 715543-241
P.O. Box 247, 4320 Aerotech Center Way New Item: (10/10)
Paso Robles, CA 93447 PAGE 5 of 8
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-11-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
TJ 241 CABLE SHIFTER
Figure 11: Remove Wire
Loom Connector Clip
Figure 12: Shifter Pivot
Assembly Bolts
6. Using a flathead screwdriver, remove the wire loom connector clip
from the transfer case shifter bracket. (See Figure 11)
7. Using an 8mm socket, remove the five transfer case shifter bracket
bolts. Make sure to save these bolts as they will be reused.
8. Using a straight screw driver or a pry bar, pry the linkage rod from
the floor shifter assembly. (fig 11A) Also pry the linkage rod from
the stock transfer case lever.(fig 11B)
9. Using a 10 mm socket, remove the four bolts securing the shifter pivot
assembly. (See Figure 12) You will have to lift up the carpet to get to
these bolts. The bracket will fall when the bolts are removed if it isn't held.
Seal the bolt holes with the four supplied black plastic plugs.
Figure 11A
Figure 11B