Advance Adapters 7155690 - Manual (Page 3)

INSTALLATION:
Install the transfer case high/low shifter arm to the top cover of the transfer case. Since Land Cruisers had two shaft
configurations, we have provided two tapped holes on this lever. Match the tapped hole with the flat portion of the shaft.
Hold the shift handles in place and mark the floor for necessary
modifications. We have designed the handles to come up through
the stock hole in the floor with only slight modifications needed to
change the shape of the hole from an L-shape to a rectangular shape.
Due to variations of drivetrains, the hole may need to be enlarged as
well as made into a rectangular shape.
Once there is sufficient clearance for the shifter handles, assemble
the pivot shaft (715579), both handles (715568M & 715570R), the
5-16" flat washer, the 5/16" lock washer, and the 5/16"-18 nut
together as a unit. Push the handles up through the floor and thread
the pivot shaft into the side of the transmission.
Now install the two 3/8" jam nuts and ball joints onto the 3/8" all
thread, and bolt this assembly to the high/low shift handle and arm.
Adjust the length so that the handle is pointing straight up when the transfer case is in neutral. (Cutting of the all thread
may be necessary for some vehicles to achieve this). Repeat this same process for the mode shifter assembly using the
5/16" all thread, jam nuts, ball joint, and female heim joint. The female heim joint mounts to the mode shaft with the supplied
clevis pin and cotter pin.
Once the transfer case shifts in a satisfactory manner, mount the shift boot over the hole in the floor using the metal ring
supplied. Use approximately 4 self tapping screws to go through the boot, metal ring, and floor. Finish the installation
by adding the 1/2" jam nuts and the shift knobs.
TOYOTA L/C FJ60/62TRANSFER CASE
TWIN STICK UNIVERSAL KIT
ADVANCE ADAPTERS INC. P/N: 715569
P.O. Box 247, 4320 Aerotech Center Way New Item: (8/02)
Paso Robles, CA 93447 PAGE 3 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 03-24-14
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.