Advance Adapters 403300 - Manual (Page 3)

Thread set screw into first pivot shaft,
insert into bracket and thread into
second pivot shaft.
ADVANCE ADAPTERS INC. P/N: 403300
P.O. Box 247, 4320 Aerotech Center Way New Item: (1/04)
Paso Robles, CA 93447 PAGE 3 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 02-25-04
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
DANA 300 TWIN STICK SHIFTER KIT
INSTALLATION OF SHIFT
LINKAGE PIVOT
1. Thread the 5/16"-18 set screw into one of the pivot shafts. Now
insert the stud & pivot shaft through the large hole in the shifter
bracket and thread the second pivot shaft into the same stud, and
tighten (see photo right).
2. Press a pivot bushing (P/N 403309) into both sides of both shift
handles using a mallet.
PRE-ASSEMBLY
Thread a 3/8"-24 jam nut onto the 3/8" male heim joint, and thread the heim joint into the
bottom of the pivot block. Now repeat for the second, jam nut, heim joint, and pivot block.
IN VEHICLE - ASSEMBLY
1. Reinstall the transfer case into the
vehicle.
2. Slide shift handles onto pivot shaft
and CHECK FLOORBOARD CLEAR-
ANCE. Depending on the rotation that
you have the Dana 300 set to, the
handles may point to the passenger or
driver's side of the vehicle. It may be
necessary to bend the shift handles
close to the pivot block to get the
shifter handles to point in the desired
direction.