Advance Adapters 403300 - Manual

ADVANCE ADAPTERS INC. P/N: 403300
P.O. Box 247, 4320 Aerotech Center Way New Item: (1/04)
Paso Robles, CA 93447 PAGE 1 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 03-18-11
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
KIT CONSITS OF:
No: Qty Part No. Description
1. 1 403301 FRONT OUTPUT SHIFT RAIL
2. 1 403302 REAR OUTPUT SHIFT RAIL
3. 1 403303 SHIFTER BRACKET
4. 2 403304 PIVOT SHAFT
5. 4 403305 HEIM JOINT LINK PLATE
6. 2 403307 SHIFTER HANDLE
7. 4 * 403309 PIVOT BUSHINGS
8. 2 403310 3/8" FEMALE HEIM JOINT
9. 2 403311 3/8" MALE HEIM JOINT
10. 2 300386 SHIFT FORK SET SCREW
11. 1 302060 TWIN STICK SHIFTER BOOT
12. 1 302061 FRONT SHIFT KNOB (SHIPPED IN SHIFTER BOOT)
13. 1 302062 REAR SHIFT KNOB (SHIPPED IN SHIFTER BOOT)
14. 1 302063 SHIFTER BOOT TRIM RING
15. 2 303121 1/2"-13 JAM NUT
16. 2 722523 1/4" FLAT WASHER
17. 6 723101 5/16"-18 JAM NUT
18. 2 723103 5/16" LOCK WASHER
19. 1 723110 5/16"-18 x 3/4" S.H.C.S.
20. 4 723151 5/16"-18 SHOULDER BOLT- 3/8" DIA. x 3/4" LONG
21. 1 723152 5/16"-18 x 1-1/4" SOCKET SET SCREW
22. 4 723719 3/8"-24 JAM NUT
23. 2 723755 3/8"-16 x 4" S.H.C.S.
24. 4 911341 3/8" SHIM WASHERS
* BUSHINGS ARE A PRESS FIT INTO THE SHIFT HANDLE BASE.
NOTE:
This assembly will require the installation of new shift rails into your
transfer case. This kit allows the Dana 300 to be shifted to the
following configurations: 2WD High, 4WD High, 4WD Low, Rear
Low, and Front Low. Refer to the exploded assembly view on the
following pages for part identification and part assembly.
This is a universal-type kit that may require the
handles to be bent for specific applications. Transfer
cases kept with a stock rotation will require the
shifter handles to be bent.
DANA 300 TWIN STICK SHIFTER KIT
NOTE: This kit requires one of the shift
rails to be modified when using it with a
4:1 low gear set. We do not offer a shift
rail with this modification already made
to it.
Optional item: P/N 403330
Aluminum shift knobs
(Black Knobs with machined letters)