Advance Adapters 300377A - Manual (Page 3)

ADVANCE ADAPTERS INC. P/N: 300377
P.O. Box 247, 4320 Aerotech Center Way New Item: (9/09)
Paso Robles, CA 93447 PAGE 3 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-07-14
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
JK ATLAS CONTROL MODULE
for NEW POLLAK SWITCHES
Notch
Fuse Splitter Installed
Figure 3: JK Power Connection
Figure 4: JK Ground Terminal
THE SWITCH CLOSEST TO THE
FRAME IS THE 4WD SWITCH
THE SWITCH CLOSEST TO
THE REAR OUTPUT IS THE
LOW RANGE SWITCH
3. Plug 12" low range pigtail into the low range switch on transfer case .Connect the Pigtail to the control
module that has the (red and Tan) wires.
4. Plug 12" 4WD pigtail on to the front output side of the shifter block. This connects to the (orange and
brown) wires on the control module.
5. Plug the 3 wire Delphi plug into the power supply you ran earlier. Note the purple wire will not be used.
2007-2011
Jeep JK
The shifter block on the
Atlas in this photo was
redesigned in 2012 and the
switches now screw into
the bottom of the shifter
block, earlier versions of
the Atlas used the switches
coming from the sides of
the shifter block. The
installation of this kit
remains the same.