Advance Adapters 300377A - Manual (Page 2)

Preparing the Wiring:
1. Unplug the connector from the transfer case position switch if the transfer case is still in the vehicle.
2. Cut the connector off the wiring harness .
3. Make sure that there is a piece of 1/4" heat shrink over both wires, and then one piece of heat shrink over
each wire that was just cut off.
4. Solder the two wire Delphi connector to the vehicle wiring harness. See the chart below for vehicle specific
wiring.
5. Heat shrink the soldered connections made in the previous step.
Installation:
1. Run the red (power) and black (ground) wires along the frame on the passenger side up to the fuse box.
Make sure to safely zip-tie the wiring away from the exhaust, any pinch points or other hot objects. The Fuse
attaches in the fuse box in the empty fuse slot labeled M14 - TTOW BUX on Jeeps up to 2011 and on
2012 JK's use slot M9. Refer to the under side of the fuse box lid for the proper location. (see photo's on
page 3 and 4)
A notch will need to be cut into the fuse box for the wire to run out, which can also be seen in Figure 3. The
ground can be run along the side of the fuse block to the ground terminal on the passenger fender next to the
fuse box.
2. Install the low range switches into the Atlas shifter block. The switches do not use the white washer that was
installed with the plug bolt and when installing use a bit of RTV silicone on the threads.
ADVANCE ADAPTERS INC. P/N: 300377
P.O. Box 247, 4320 Aerotech Center Way New Item: (9/09)
Paso Robles, CA 93447 PAGE 2 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-07-14
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
JK ATLAS CONTROL MODULE
for NEW POLLAK SWITCHES
07-12 JK