Advance Adapters 50-3703 - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 50-3703
P.O. Box 247, 4320 Aerotech Center Way New Item: (1994)
Paso Robles, CA 93447 PAGE 2 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-23-94
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that
a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
700R-4 TO TOYOTA 4WD T/C 26T INPUT
1987 & UP TOYOTA TRUCK 4WD VEHICLES
700R-4 4 SPEED AUTOMATIC:
The GM 700R-4 has a case length of 23-3/8" and is available in the GM engine pattern only. The rear side of the
transmission case will have a square bolt pattern that utilizes 4 metric bolts. There are several variations to the output
shaft lengths and since you are installing a new output shaft, any of the 700R-4 transmissions will be acceptable. You
will need to replace the original shaft with the new Advance Adapter output shaft. The rear transmission support is
located on the main case just forward of the tailhousing. We recommend that you only use the Toyota transfer case
support area.
When installing the new transfer case adapter, make sure that the coupler and the output shaft do not bottom out.
When assembling the adapter housing to the transmission case, we have provided you with a new square-type "O"
ring seal to prevent fluid leakage. This seal is a stock GM item that is used on all TH350 installations.
If you have selected a transmission that has the old style modulator, then we recommend the use of the Advance
Adapters adjustable modulator, Part No. 716010. This will also allow for additional driveshaft clearance.
All installations will require the use of a transmission cooler. The cooler can be either installed in the radiator or a remote
location is acceptable. The transmission shift control can either be a Hurst floor mounted type shifter or sometimes
the existing column shift can be modified on certain applications.