Advance Adapters 50-2905 User Manual

Page 3

Apply a thin film of silicone to the back
flange of the C4 transmission and using a
mallet, tap the 51-2902 steel plate over the
governor housing. Fasten with the 3/8"-
16 socket head cap screws. Torque to
factory specs.

Check operation of the transmission park
gear. Verify that the transmission will shift
in and out of park without any binding.

you encounter any problems, do not pro-
ceed.

Remove the plate and find and elimi-

nate the interference. If you should need
further assistance, please call us at 1-800-
350-2223.

Apply a thin film of silicone to the 51-9201
casting that mates to the steel adapter
plate. Slide 51-9201 aluminum adapter
over the studs and lightly tap into place
with a mallet. Install star washers and nuts.

10. Prepare the transfer case for the installation by

threading P/N #302069 studs (included with the
Atlas transfer case.) into the transfer case input
ring.

11. Pre-assemble the P/N 716055 crossmember

mount according to the instructions included
with that kit.

12. Insert the transfer case studs into the adapter

until the studs just begin to protrude through the
adapter. Slide the crossmember mount into place
and over the transfer case studs. Push the
transfer case the remaining distance so that it is
completely seated into the adapter. Install the
star washers and the 3/8"-24 nuts.

FORD C-4 300M TO ATLAS

TRANSFER CASE- SHORT

ADVANCE ADAPTERS INC.

P/N: 50-2903

P.O. Box 247, 4320 Aerotech Center Way

New Item: (3/04)

Paso Robles, CA 93447

PAGE 3 OF 4

Telephone: (800) 350-2223

Fax: (805) 238-4201

Page Rev. Date:

09-30-08

SPECIAL NOTE:

The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will

void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.