Advance Adapters 50-2706 - Manual

ADVANCE ADAPTERS INC. P/N: 50-2706
P.O. Box 247, 4320 Aerotech Center Way New Item: (10/96)
Paso Robles, CA 93447 PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 05-06-11
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
KIT CONSISTS OF:
No.
Qty Part No. Description
700R TO BRONCO DANA 20 TRANSFER CASE
1. 1 51-0209 CASTING - NV4500 TO BRONCO DANA 20
2. 1 51-6800 THIN CASTING - TH350 TO JEEP NEW PROCESS
3. 1 52-0209 SPUD SHAFT - NV4500/BRONCO DANA 20
4. 1 52-9101 SHAFT - 700R4 TO 23 SPLINE
5. 1 715523-SP SPACER FOR SHIFTER BRKT TO CASTING
6. 1 715541 SHIFTER LINKAGE BRACKET
7. 1 716082 700R NYLON BUSHING
8. 1 716223 BEARING RETAINER
9. 1 716312 BEARING
10. 1 716455 SNAP RING
11. 1 716511 "O" RING
12. 1 716513 T/C GASKET
13. 1 716517 GASKET- NP208 T/C
14. 1 716713 SEAL
15. 1 716714 O-RING FOR INDEX RETAINER
16. 4 720046 10mm-1.5 THREAD x 40mm S.H.C.S.
17. 6 723701 NUT 3/8"-16 PLATED
18. 6 723704 LOCK WASHER 3/8" PLATED
19. 6 723711 STUD BOLT 3/8"-16 x 2" LG
20. 6 723740 H.H.C.S. 3/8"-16 x 1-1/2"
NOTE NOTE NOTE NOTE NOTE :::::
This adapter will only work with
the "T" style shifter. If your
vehicle has a "J" style, it will
need to be replaced
Optional items:
Part# 712588
(GM Trans x Ford Small Block)
SPECIAL INSTRUCTIONS:
This adapter kit is designed for exclusive use with a GM
700R transmission. The overall length of this transmis-
sion with the adapter is 25-7/8". Since this application
is for a Ford Early Bronco Model 20 transfer case, you
will need to consider how to couple the 700R to the Ford
engine. We offer
P/N 712588 which will allow you to
obtain this conversion. The overall length of your
assembly with P/N 712588 will now be 26.25".
This kit is supplied with a new spud shaft, bearing, and
seal. These components will need to be installed into our
alignment retainer, along with the stock Bronco Dana
drive gear. Make sure all snap rings are in place. Install
the O-ring on the retainer along with a small amount of
R.T.V. Blue silicone, then install the retainer to your
transfer case. Bolt the adapter ring to the Dana 20 using