Advance Adapters 50-0435 - Manual (Page 4)

ADVANCE ADAPTERS, INC. P/N: 50-0435
P. O. Box 247, 4320 Aerotech Center Way New Item: (01/07)
Paso Robles, CA 93447 PAGE: 4 of 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 03-28-12
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific types of conversions. Modifications to any of
the components will void any possible warranty or return privileges. If you do not fully understand the modifications or changes that will be required to
complete your conversion, we strongly recommend that you contact our sales department for more information. This Instruction Sheet is only to be used
for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque vales,
wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts stores.
GM 4L60E 4WD HEX BOLT PATTERN TO JEEP
NP231 T/C (27-SPLINES) 1995 & NEWER
Loctite on these set screws is recommended.
Trial fit the 51-0405 adapter and 300619 sensor back on the transmission and make sure the reluctor ring teeth and sensor still
line up properly.
RTV Blue Silicone should be used to seal the 51-0405 adapter to your 4L60E transmission. Screw the 300619
sensor completely into the 51-0405 casting. With a feeler gauge, check the gap between the sensor and the reluctor ring. This
gap should be around 0.010" to 0.012". Once 0.010" to 0.012" clearance is obtained, loctite the sensor into position.
Sensor note: This sensor will match up with the GM pigtail P/N 12162193 or Carquest P/N TX3A.
Once the 51-0405 is installed, install the 4 metric studs into the this adapter. Install the o-ring gasket on the 51-9111 adapter and
bolt it to the 51-0405 casting. NOTE: The output shaft on the transmission should have a slight stick out past the adapter with the
(51-9111) casting installed. The stock NP231 studs should be retained to install the transfer case to the new adapter kit. The casting
has two rotations options.