Advance Adapters 50-0222 - Manual (Page 2)

DODGE NV4500 5 SPEED 29 SPLINE OUTPUT
TO TOYOTA L/C 10 SPLINE
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that
a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
ADVANCE ADAPTERS INC. P/N: 50-0222
P.O. Box 247, 4320 Aerotech Center Way New Item: (02/98)
Paso Robles, CA 93447 PAGE 2 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-06-01
NOTE:
1. This adapter is designed for exclusive use of the Dodge 4WD 29 spline output version of the NV Model 4500
transmission. You must use this transmission due to the length and spline size of the output shaft. The shaft must
be shortened to the 5.420" cutoff length (see Page 3). In order to cut the shaft off, you will need to remove the
tailhousing. The shaft can be cutoff using and abrasive cutoff saw or a skill saw equipped with a special metal cutting
blade. Be sure to use safety glasses during this procedure.
2. The assembly of the adapter plate to the transfer case should be very much like the originally transmission that is being
replaced. A new flat washer and nut are provided for the early model vehicles to hold the two gears in position.
3. The alignment between the new adapter plate and transfer case must be performed by the new bearing that has been
included with the adapter. This bearing will have the external snap ring on the outside of the adapter similar to the
original transmission. When installing the adapter to the NV4500 make sure the stock dowel pins are in the
transmission.
4. When using this transmission assembly with a 6 cylinder Toyota engine, you may need to modify the gas tank area
on 1979 and newer vehicles. It would be advisable that your vehicle be equipped with a suspension lift and you should
plan on removal of the stock rear crossmember. A new Advance Adapter crossmember #716022-TSW, will be
required. This transmission assembly is the very shortest possible and careful planning is a must when performing
the installation with the stock 6 cylinder.
5. The transfer case shift controls will need to be modified for use with the new transmission.