Advance Adapters 50-0214 - Manual (Page 2)

NEW VENTURE MODEL 4500 5 SPEED
TO TOYOTA L/C 19 SPLINE (Short Design)
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend
that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
ADVANCE ADAPTERS INC. P/N: 50-0214
P.O. Box 247, 4320 Aerotech Center Way New Item: (05/95)
Paso Robles, CA 93447 PAGE 2 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 04-26-10
INSTALLATION NOTES:
1. This adapter is designed for exclusive use of the 4WD General Motors version of the New Venture Model 4500
transmission. You must use this transmission due to the length and spline size of the output shaft. The shaft must
be shortened to the 4.498" cutoff length. In order to cut the shaft off, you will need to remove the tailhousing. The
shaft can be cutoff using and abrasive cutoff saw or a skill saw equipped with a special metal cutting blade. Be sure
to use safety glasses during this procedure. You must remove the harmonic balancer and install the 2 piece set collar.
2. The assembly of the adapter plate to the transfer case should be very much like the originally transmission that is being
replaced. The stock transfer case lock nut is retained to hold the two gears in position. The stock Toyota nut is
P/N 90179-26004.
3. The alignment between the new adapter plate and transfer case must be performed by the new bearing that has been
included with the adapter. This bearing will have the external snap ring on the outside of the adapter similar to the
original transmission.
4. When using this transmission assembly with a 6 cylinder Toyota engine, you may need to modify the gas tank area
on 1979 and newer vehicles. It would be advisable that your vehicle be equipped with a suspension lift. 1980 to 1985
vehicles require a custom crossmember to be made for the new transmission assembly. On 1986 & newer vehicles,
the original crossmember can be modified.
5. The transfer case shift controls will need to be modified for use with the new transmission. In order to have clearance
for the gas tank area, special shifter modifications may be necessary. A new bracket has been included that will allow
the original 4 speed transfer case pivot stud to be relocated on the passenger side of the new transmission. Be sure
to assemble this prior to positioning into the vehicle. Slight modifications may be necessary.
NOTE:
This casting is used for both the early and late Land Cruiser transfer cases. When bolting your transfer case
to the new adapter, you will find one hole on the casting that is not used. We recommend using a dab of RTV
Blue Silicone to plug this hole.