Advance Adapters 713027-EK User Manual
Page 2

ADVANCE ADAPTERS INC.
P/N: 713027-EK
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 2 OF 2
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
01-31-14
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.
TOYOTA LAND CRUISER 4 SPEED TO
CHEVY LS GEN 3 - MARK'S 4WD ADAPTORS
NOTE:
1.
Thrust tube must be installed prior to release bearing and ring assembly.
2.
Make sure that bearing support ring is installed first and then release bearing collar.
3.
If assembled before, you will find that the assembly will not fit through flywheel housing bore.
4.
This kit fits with both the stock Toyota cast iron and stamped steel release arms.
5.
The new release collar is designed to fit both release arms. When using the cast iron arm, new clips have
been provided to connect the arm to the collar. The small square metal blocks need to be installed on
the new collar and Loctite into position.
SPECIAL GEN 3
11" CLUTCH