Advance Adapters 712588 User Manual
Page 3

ADVANCE ADAPTERS INC.
P/N: 712588
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 3 OF 5
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
11-12-10
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
FORD SMALL BLOCK 302 TO
CHEVY AUTOMATIC TRANSMISSIONS
6.
"Check fit" the torque converter adapter ring on the GM torque converter for full engagement. The flat surface of the ring must
lay flat against the bolt surfaces of the torque converter. Some older torque converters may need to be deburred on the index
hub.
7.
Bolt the torque converter adapter ring to the torque converter with the three (3) bolts supplied. The recommended torque
specification is 35 ft./lbs.
8.
Install the starter, making sure that the proper index is accomplished. The starter must be for a Ford small block automatic
transmission application ONLY! If a starter for a manual transmission is used, the Bendix will not achieve proper contact
on the flexplate. Ford starters from small blocks and these transmission C4, C6, AOD, AODE, 4R70W are all the same.
C4 automatic starter