Advance Adapters 712583 - Manual (Page 3)

BUICK BELLHOUSING FOR USE WITH
JEEP T4, T5, SR4 & T176 TRANSMISSIONS
ADVANCE ADAPTERS INC. P/N: 712583
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 3 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 02-12-02
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service manual
pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and
parts stores.
NOTES:
1. Be sure to grease inside pocket diameter of bearing. This will provide lubrication on the bearing retainer.
2. Release bearing should have .060" clearance between fingers and face of bearing.
3. Clutch disc should have .030" clearance between flywheel and disc when fully disengaged.
CLUTCH ITEMS:
CLUTCH PRESSURE PLATE (PART #CF360056, HIGH-PROFILE.)
CLUTCH DISC. (PART #383271, 1-1/8" 10 SPL.) (T4, T5, SR4 & T176)
CLUTCH DISC. (PART #381021, 1-1/16" 10 SPL.) (T150)
CLUTCH RELEASE BEARING (PART #N1714)
RECESSED FLYWHEEL CLUTCH ITEMS:
CLUTCH PRESSURE PLATE. (PART #CF361662)
CLUTCH DISC. (PART #383271, 1-1/8" 10 SPL.) (T4, T5, SR4 & T176)
CLUTCH DISC. (PART #381021, 1-1/16" 10 SPL.)
CLUTCH RELEASE BEARING (PART #N1178)
The transmission bearing retainer snout may require machining.
This release bearing has a 1.377" I.D.
Flywheel should not require a change in thickness.