Snorkel MHP44 - Manual (Page 15)

MHP15/44 – 12459A page 1 - 7
1. Safety
WARNING
KEEP LINES CLEAR POWER OF
Unless the Electrical Supply Authority has advised
in writing otherwise;
the clearance between any live overhead
power line and any part of this machine or
load carried is required by law to be
AT LEAST 4 METRES
This is a requirement of regulation 93 of the
Electrical Supply Regulations 1984
in the interests of safe working.
DANGER
BEWARE OF ELECTRICAL HAZARDS
REGULATION 133A OF THE
CONSTRUCTION SAFETY ACT 1912 REQUIRES
(a) Minimum approach of an appliance
(b) Inspection of the work site for
(c) Constant vigilance and an observer required
to live electrical apparatus.
electrical hazards before
commencing to use the appliance.
whilst working or travelling the appliance
in the vicinity of live electrical apparatus.
3m. for voltages up to 132,000
6m. for voltages above 132,000
and up to 330,000
8m. for voltages above 330,000
(New Zealand Only)
(Australia Only)
CAUTION
EACH PERSON ON THE PLATFORM
MUST WEAR A FULL SAFETY HARNESS
WITH LEG STRAPS
AND ENERGY ABSORBING LANYARD
ATTACHED TO AN APPROVED ANCHOR
POINT IN THE PLATFORM
99228-1
RATED LOAD
440 LB
12423-200
200
KG
Attach lanyard
of fall restraint
to loop below
0150448
RATED LOAD
500 LB
12423-227
227
KG
Note: Rated capacity depends on the configuration of the machine
see Chapter 3 - Specifications
NOTE:
Refer to Placards and Decals Inspection Chart and Drawing in the “Daily Inspection and
Maintenance” chapter 7, for part numbers, location, and required quantities of all placards and
decals.