Snorkel AB80J - Manual (Page 64)

Chapter 9 – Stowing and Transporting
60 AB80J/AB85J – 0420453
2. Raise the main boom about 1′ (0.3m).
3. Place a large wood block under the jib foot. Lower
the platform so the foot rests on the wood block.
4. Remove all personnel, tools, materials, or other loose
objects from the platform.
5. Turn the start switch off and place the platform con-
trol cover over the upper controls if the machine is
equipped with that option.
6. Place the lower controls emergency stop switch in
the off position. Turn the start switch off and remove
the key.
7. Turn the battery disconnect switch off.
8. Close the shut-off valve on the LPG tank on LPG.
9. Close and latch the cowling doors.
10. Use wire-ties to fasten the platform gate to the
guardrails to prevent the gate from bouncing. Also,
use wire-ties to fasten the platform foot switch to the
platform floor.
11. Use a nylon strap to securely fasten the platform
against the wood block. On steel platforms, thread
the strap over the toeboard as shown in Figure 9.6.
Figure 9.6 – Platform
Caution
Ratchets, winches, and come-alongs can produce
enough force to damage machine components. Do
not over tighten the straps or chains when securing
the aerial platform to the transport vehicle.
12. Use chains or straps to securely fasten the aerial
platform to the transport vehicle using the tie-down
lugs as attachment points. Proper tie-down and haul-
ing are the responsibility of the carrier.