beautypg.com

Maintenance, Blocking elevating assembly, Installation – Snorkel XRT33-sn1000-2299CE User Manual

Page 9: Removal, Figure 10)

background image

9

Maintenance

Never perform service on the work platform
in the elevating assembly area while platform
is elevated without first blocking the elevating
assembly.

DO NOT stand in elevating assembly area
while deploying or storing brace.

Blocking Elevating Assembly

(Figure 10)

Installation

1. Park the work platform on firm level ground.

2. Verify platform emergency stop switch is ON.

3. Turn platform/chassis switch to CHASSIS.

4. Start the engine using the chassis controls.

5. Push the throttle button in, the button will stay in

and the engine speed will increase. Using the
raise button, elevate platform until the scissors
brace can be rotated to the vertical position.

6. XRT33 – From the left side of the machine,

disengage the locking pin securing the brace.
Rotate the scissor brace counterclockwise until
it is vertical and between the two scissor center
pivots.

7. XRT27 – From rear of machine, lift the scissor

brace from its stowed position. Rotate upward
and outward then down until it is hanging vertical
below its attachment point.

8. Push lower button and gradually lower platform

until brace is supporting the platform.

9. Disengage throttle by pushing throttle button in

again, the button will retract and the engine will
come to idle speed.

Removal

1. Using chassis controls, gradually raise platform

until the scissors brace clears the two scissor
center pivots.

2. XRT33 – Rotate scissors brace clockwise until

the locking pin engages.

3. XRT27 – Rotate scissor brace outward and

upward over its mounting point until it rests in the
stowed position.

4. Push lower button to completely lower platform.

5. Make sure the throttle button is disengaged and

platform/chassis switch is on PLATFORM.

Figure 10: Blocking Elevating Assembly

BRACE RESTS ON

WELDMENT WHEN IN

BLOCKING POSITION

ROTATE BRACE

CLOCKWISE

TO BLOCK

SCISSOR BRACE IN

REST POSITION

BRACE ROTATES

TO BLOCKING

POSITION

BRACE RESTS ON

PIN WHEN IN

BLOCKING POSITION

PIN RESTS ON

BRACE WHEN IN

BLOCKING POSITION

XRT27

XRT33

This manual is related to the following products: