Snorkel XRT33-sn1000-2299CE - Manual (Page 11)

11
Routine Service
Use the following table as a guide for routine
maintenance. Inspection and maintenance
shall be performed by personnel who are
trained and familiar with mechanical and
electrical procedures. Refer to the Service
Manual for complete service instructions.
Please copy this page and use the Routine
Service Table as a checklist when inspecting a
machine for service.
COMPONENT INSPECTION OR SERVICES INTERVAL A N R
Engine Oil Check level and condition Daily
Check for leaks Daily
Change oil & filter (Dual Fuel) 30 D
Change oil & filter (Diesel) 100 HOURS
Engine Fuel Check fuel level Daily
System Check for leaks Daily
Replace fuel filter 6 M
Check air cleaner Daily
Engine Check electrolyte level Daily
Battery Check specific gravity 30 D
System Clean exterior 6 M
Check battery cable condition Daily
Clean terminals 6 M
Engine Check coolant level (with engine cold) Daily
Coolant Replace coolant 3 M
Hydraulic Check oil level Daily
Oil Change filter 6 M
Drain and replace oil 2 Y
Hydraulic Check for leaks Daily
System Check hose connections 30 D
Check hoses for exterior wear 30 D
Emergency Operate the emergency lowering system
Hydraulic and check for serviceability Daily
System
Controller Check switch operation Daily
Control Check the exterior of the cable
Daily
Cable for pinching, binding or wear
Platform Check fasteners for proper torque Daily
Deck and Check welds for cracks Daily
Rails
Check condition of deck Daily
Tires Check for damage Daily
Check air pressure (unless foam filled)
(4.5 bar) (65 psi)
Daily
Check lug nuts (torque to 123 N·m
[90 ft. lbs.])
30 D
Hydraulic Wipe clean 30 D
Pump Check for leaks at mating surfaces 30 D
Check for hose fitting leaks Daily
Check mounting bolts for proper torque 30 D
Routine Service Table Key
Interval
Daily = each shift (every day) or every eight hours
30
D = every month (30 days) or every 50 hours
3
M
= every 3 months or 125 hours
6
M
= every 6 months or 250 hours
1
Y
= every year or 500 hours
2 Y = every 2 years or 1000 hours
A = Acceptable
N = No/Not Acceptable
R = Repaired/Acceptable
Service Report
Date: __________________________________
Owner: ________________________________
Model No: ___________ Serial No: _________
Serviced By: ____________________________
Service Interval: _________________________
COMPONENT INSPECTION OR SERVICES INTERVAL A N R
Drive Motors Check for operation and leaks Daily
Steering Check hardware & fittings for proper torque 6 M
System Oil all pivot points 30 D
Check steering cylinder for leaks & mounting
30 D
bolts for proper torque
Elevating Inspect for structural cracks Daily
Assembly Check pivot points for wear 30 D
Check pivot pin mounting bolts for proper
30 D torque
Check scissor arms for bending 6 M
Chassis Check hoses for pinch or rubbing points Daily
Check component mounting for proper
torque
6 M
Check welds for cracks Daily
Lift Check the cylinder rod for wear 30 D
Cylinder Check pivot pin mounting bolts for
proper torque
30 D
Check seals for leaks 30 D
Inspect pivot points for wear 30 D
Check fittings for proper torque 30 D
Entire Check for and repair collision damage Daily
Unit Check fasteners for proper torque 3 M
Check for corrosion-remove and repaint 6 M
Lubricate 30 D
Labels Check for peeling, missing, or unreadable Daily
labels & replace
Routine Service Table