Snorkel XRT33-sn1000-2299CE - Manual (Page 7)

7
Fold Down Guardrails
This procedure is only for passing through doorways.
Guardrails must be returned to proper position before
using the machine.
Fold Down Procedure (Figure 7)
Note: When performing the following procedures
retain all fasteners.
1. Ensure that the slide out deck extension is fully
retracted and deck pin is locked. Place the
controller on the platform.
2. Pull the pins on the two end gate arms. Lower
the rear gate to the floor. Replace the pins.
3. Pull the pins (2) on the left side of the front rail
and swing the front rail back against the right
handrail. Insert pins into right handrail.
4. Lift the right handrail up, then lower it to the
extension deck floor.
5. Push the deck extension handle into locked
position. Lift the left handrail up, then lower it on
top of the right handrail.
Figure 7: Fold Down Guardrails
Before operating machine, guardrails
must be securely fastened in their proper
position.
6. Rotate the arms in against handrails.
7. Lift the right main handrail and lower to the floor.
8. Lift the left main handrail and lower it on top of
right hand rail.
Erection Procedure
1. Reverse the fold down procedure.
2. Hang the controller from front guardrail.
3. Before operating the work platform, check that all
fasteners are in place.
Deck
Extension
Handle
3
4
6
8
7
5
1
6
2