Snorkel XRT33-sn1000-2299CE - Manual (Page 2)

2
SAFETY RULES
USE OF THE AERIAL WORK PLATFORM: This aerial work platform is intended to lift persons and his tools as well
as the material used for the job. It is designed for repair and assembly jobs and assignments at overhead workplaces
(ceilings, cranes, roof structures, buildings etc.). All other uses of the aerial work platform are prohibited.
THIS AERIAL WORK PLATFORM IS NOT INSULATED! For this reason it is imperative to keep a safe distance from
live parts of electrical equipment.
ALL occupants must wear an approved fall restraint properly attached to a designated platform anchorage point.
Attach only one fall restraint to each anchorage point.
Exceeding the specified permissible maximum load 455 kg (1000 lbs.) or Four persons on the platform is prohibited.
The use and operation of the aerial work platform as a lifting tool or crane (lifting loads from below upwards or from up
high on down) is prohibited!
NEVER exceed 200 N (45 lbs.) of side force per occupant.
DISTRIBUTE all loads evenly on the platform. See the "Specifications" for maximum platform load.
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs,
bumps, curbs, or debris; and avoiding them.
OPERATE machine only on surfaces capable of supporting wheel loads.
NEVER operate the machine when wind speeds exceed 45 km/h (28 mph) (12.5 m/sec.=Beaufort scale 6).
IN CASE OF EMERGENCY push emergency stop button to deactivate all powered functions.
Climbing up the railing of the platform, standing on or stepping from the platform onto buildings, steel or prefab con-
crete structures, etc., is prohibited!
Dismanteling the swing gate or the liftable bar or other railing components is prohibited! Always make certain that the
swing gate or liftable bar is closed and securely locked! It is prohibited to keep the swing gate or liftable bar in an
open postiion (e.g. held open with tie straps) when the platform is raised!
To extend the height or the range by placing of ladders, scaffolds or similar devices on the platform is prohibited!
INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control cable, loose
wire connections and wheel bolts before using.
VERIFY that all labels are in place and legible before using machine.
NEVER climb down elevating assembly with the platform elevated.
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
NEVER recharge battery near sparks or open flame. Batteries that are being charged emit explosive hydrogen gas.
AFTER USE secure the work platform against unauthorized use by turning key switch off and removing key.
NEVER replace any component or part with anything other than original UpRight replacement parts without the
manufacturer's consent.
IF ALARM SOUNDS while platform is eleveted, STOP, carefully lower platform. Move machine to a firm level surface.
To bypass any safety equipment is prohibited and presents a danger for the person on the aerial work platform and in
its working range.
English Language Section
NEVER elevate or drive
elevated on uneven
slopes or soft ground or
elevate the platform un-
less the platform is level.
Tip Over Hazard
NEVER sit, stand or
climb on guardrail or
midrail.
Fall Hazard
NEVER position the
platform without
checking for overhead
obstructions.
Collision Hazard
THIS MACHINE IS
NOT INSULATED
Electrocution Hazard