Smittybilt 76622 Rear Bumper - Manual (Page 11)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions:
XRC & SRC (76856,76622) Rear
Bumper with Tire Carrier.
07-10 Jeep JK (Wrangler/Unlimited)
1. After the bumper is installed, follow the installation instructions for the tire carrier included with it.
Make sure to close and latch the tire carrier first with no load before tightening any of the
hardware. (Fig A,B)
(Fig A) (Fig B)
2. If the lock pin on the back of your handle does not go into the keyhole on the latch bracket easily
(horizontally) you can loosen the two bolts on the handle block and move slightly inward or
outward. (Fig C,D)
(Fig C) (Fig D)
Install tire carrier on bumper with handle, then close
and latch. Then proceed to tighten the hardware.
If the lock pin on the back of your handle
does not go into the keyhole on the latch
bracket easily (horizontally).
You can loosen the two bolts on the handle
block and move slightly inward or outward.
When handle is locked, it should be in the 3 o’clock
position.