Smittybilt T0786QC Nerf-Step User Manual
Installation instructions
WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Compton, CA 90220
Installation Instructions
Nerf-Step (Part # T0786CC, T0786QC)
07-10 Toyota Tundra Double Cab/ Crew Cab
4-Door Short Bed
NOTE: Carefully read entire instructions thoroughly before attempting to install this part.
It is recommended to have some additional help while installing these bars.
Parts Included Qty
Tools Required
8mm x 25mm hex bolts 16
13mm Ratchet with socket or Wrench
5/16” Flat Washer 8
12mm wrench or socket (used to remove factory bolts)
5/16” Lock Washer 8
Picture is for sample use, may not be actual bars
STEP 1:
Remove any factory hardware and discard.
Position the step board on the side of the
vehicle. See Figure 1.
NOTE: The short end of the step goes to the front of
the vehicle. Test fit the step board to the
factory bolt hole locations.
Fig 1
NOTE: The step should line up with the existing
factory bolt locations.