Smittybilt 17290 Bolt-On Fender Flares - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Bolt-On Fender Flares
Chevy Silverado 1500,2500,3500
(07-13)
Part #17290
Hardware Included QTY Hardware Included QTY Bolt Kit Included QTY
Extrusion 27ft Alcohol Towelette 4 Black Hex Bolts 42
CLIP .6mm 12 Nuts 42
Washers 42
Please read instructions entirely before installing this product.
Ensure that both left and right hand Fender Flares suit the profile of the vehicle. Note the areas where the Fender Flares
come in contact with the vehicle. NOTE: Before fitting Fender Flares remove any moldings, strips or existing flares from
the wheel arch. If there is a body side molding, mark where the molding is to be cut, alternatively the Fender Flare can
be cut to go around the molding. Be sure to allow enough room for the extrusion.
*PRIOR TO ANY PAINTING & INSTALLATION, PRODUCT SHOULD BE THOROUGHLY
INSPECTED FOR ALL COMPONENTS LISTED ABOVE. PRODUCT SHOULD ALSO BE TEST
FITTED PRIOR TO ANY PAINTING & INSTALLATION. PLEASE CONTACT SMITTYBILT IF YOU
HAVE ANY FITMENT QUESTIONS AND OR MISSING COMPONENTS.
PAINTING INSTRUCTIONS – If Fender Flares are being painted; do not install edge extrusion until painting is complete.
Prior to painting, clean all surfaces to be painted using clean water and a mild detergent, do not use lacquer thinner or
any solvent based products. Wipe completely dry. Best results will be achieved by wiping the areas to be painted with a
tack rag just prior to painting. Most automotive paints can be applied directly to the Fender Flares, however some may
require a primer (check paint manufacturer specifications). Good adhesion will be achieved without sanding. Select a
paint (and primer if necessary) that is suitable for rigid plastics PMMA (Acrylic). If using a paint system that requires
baking, do not expose the product to temperatures above 70°C (158°F). Do not fit the extrusion or any of the hardware
to the Fender Flares until the paint is completely dry.
STEP 1: Attach the 9 bolts, washers and nuts to each
Fender Flare using a 5/32” Allen key and a 3/8”
wrench/socket. (wrench/socket and Allen key not supplied).
Ensure inside of Fender Flares where the rubber seal is
attached is clean, using the alcohol wipes provided. Wipe
away any residue with a dry clean cloth.
STEP 2: Attach the included rubber seal to the Fender
Flares. Peel back 2” of the adhesive backing and position
on the Fender Flare. Attach the seal to the Fender Flare,
peeling back a few inches at a time. Ensure pressure is
used to secure rubber seal to Fender Flare edge. Attach
rubber seal along all areas the Fender Flare will make
contact with the vehicle body.