Smittybilt 886257 Billet Grille (Overlay) - Manual

Smittybilt Automotive Products., 886257
400 W. Artesia Blvd Compton CA. 90220 11/11/09
Customer Service / Technical Support: (888) 717-5797
Installation Instructions
Billet Grille (Overlay)
08-on Ford Super Duty 6PC
Part#: 886257
TOOLS REQUIRED
-- Phillips Screw Driver
-- 4mm wrench
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE STARTING THE INSTALLATION. THE
MANUFACTURER IS IN NO WAY RESPONSIBLE FOR ANY PERSONAL INJURY OR VEHICLE DAMAGE THAT MAY
OCCUR DURING THE INSTALLATION.
INCLUDED COMPONENTS
1 – Billet Grille(6 pieces)
20 – Metal Brackets
20 – M4 x50mm Phillips Screws
6 – M4 x35mm Phillips Screws
26 – M4 Flange Nuts
INSTALLATION INSTRUCTIONS FOR GRILLE SHELL IN FIGURE 2
1. Inspect product and check components with items listed above.
2. Pop Hood. Position all Billet Grille onto grille shell cavity (Figure 3).
3. Loosely attach the Billet Grille by holding the Metal Brackets behind factory grille shell and inserting the Phillips Screws (from
the front) through the Billet Grille holes and Metal Brackets, secure them with Flange Nuts provided (Figure 4).
4. Repeat Steps 3 for each section of Billet Grille.
5. Once the Billet Grilles are loosely attached, center them and tighten all Phillips Screws at the same rate.
INSTALLATION INSTRUCTIONS FOR GRILLE SHELL IN FIGURE 5
1. Inspect product and check components with items listed above.
2. Pop Hood. Position all Billet Grille onto grille shell cavity (Figure 6).
3. Loosely attach the Billet Grille by holding the Metal Brackets behind factory grille shell and inserting the Phillips Screws (from
the front) through the Billet Grille holes and Metal Brackets, secure them with Flange Nuts provided (Figure 6).
4. Once the Billet Grilles are loosely attached, center them and tighten all Phillips Screws at the same rate.
Figure 4 – Rear view of vehicle’s shell; Billet Grills
attached with Metal Brackets and Flange Nuts
Figure 2 – Grille shell with grid
Figure 1 – Included Hardware
Figure 3 – Front View of positioning all six Billet Grille
Figure 5 – Grille shell with uprights
Figure 6 – Front View of positioning all six Billet Grille
Figure 7 – Rear view of vehicle’s shell; Billet Grills
attached with Metal Brackets and Flange Nuts