Smittybilt SB76612 SRC Bumper - Manual (Page 3)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W. Artesia, Compton, CA 90220
Installation Instructions
SRC Bumper (Part # SB76612)
2007 Jeep JK SRC Rear Bumper
Revised 12.9.09
Step 6: Install the (4) ½” X 1 ¼” into the previously installed nut plates (90-3925), (2) on
the driver’s side, (2) on the pass side. Level the bumper and torque the bolts to 90 ft./lbs. (Fig
E)
(Fig
E)
Step 7: Torque the (4) hitch plate bolts to 90 ft./lbs. (Fig D)
Step 8: Installation is now complete.
Product cleaning and maintenance instructions
Stainless Steel Finish – Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap, window or glass cleaner may be used to clean the finish. Dual state powder coat finish – Mild soap, win-
dow or glass cleaner may be used to clean the finish. In order to protect the finish, you may wax your product on a
regular basis with pure carnauba automotive wax. Do not use any types of soap, polish or was that contains abra-
sive that could damage the finish. Textured coated finishes should be cleaned with a mild soap on a damp
sponge. Do not apply polish or was that requires to be removed by means of buffing. This type of wax is com-
monly used at car wash facilities. Chrome Finish – Mild soap, window or glass cleaner may be used to clean the
finish. In order to protect the finish you should wax your product on a regular basis with pure carnauba automotive
wax. Do not use any types of soap, polish or was that contains abrasive that could damage the finish.
(2) 1/2”
X 1 1/4”
Bolts
Pass side view