Installation instructions, 06 jeep hardtop (1-piece) – Smittybilt 519801 Hardtop (1-piece) User Manual
Page 5
WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
97-06 Jeep Hardtop (1-piece)
Part # 519701 (without doors)
Part # 519801 (with doors)
(Fig K)
(Fig L)
ADJUSTMENTS
Due to the variances in vehicles; adjustments may need to be made.
1. If the back side of the door is hitting the top, unhook the windshield latches, loosen the rear mounting
bolts and then push top backwards. Re-tighten the rear bolts and re adjust front latches.
2. If the top of the door is hitting the top, you can shim the top. Unlatch the front of the top and remove
the rear bolts. You can shim top simply by placing the needed amount of flat washers over the
mounting holes on the vehicle and the replace top over and reattach bolts.
3. You can also make adjustments to the lower doors by slightly loosening the door bolts using a T40
torx bit and reposition the door for an improved fit.
CARE AND MAINTENANCE
Wash and clean using a soft cloth and non abrasive soap and water. DO NOT use automotive past
wax or something similar that use fillers like Armor all. It is recommend to use something like Auto
Glym plastic conditioner. It contains weather resistant resin polymers to help reduce the aging effect
cause by sunlight, water and other elements. It is available at most automotive detail outlets.