Smittybilt 2763 Rear Storage Vault - Manual (Page 3)

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Rear Storage Vault
07-12 Wrangler & Unlimited
Part # 2763
Front / Inside Mounting
On some 4-door models you can mount the front right side of the box using the included “L” bracket.
Remove the strap bracket located in front of the 12v outlet using a #30 Torx bit. (Fig J) Place the included
“L” bracket over hole and secure using the bolt you just removed. Use a scribe or other sharp object to mark
hole on the side of the box then remove bracket and drill a 5/16” hole. (Fig F, G)
On other models you will need to drill both holes in the front, using the pre-drilled holes in the bottom of
the box as a template. If you did not use the “L” brackets on the rear of the box there are 4 holes on the inside
of the box base to use as mounting points. Making sure box is in desired location mark the holes using a white
wax or paint pin in order to show up on the carpet. (Fig K) Be sure too note the location of the box in order
for the holes to lineup when installing the screws. Remove the box and set to the side. Its recommended to cut
a small hole in the carpet where marked in order to install the screws easier. (Fig H) Drill a pilot hole through
the carpet and floor. (Fig L) Set box back into vehicle in the same location it was previously in. (Fig C)
Secure with self tapping screw and fender washer. (Fig M) Do not tighten completely at this time.
(Fig I) (Fig J) (Fig K)
(Fig L) (Fig M) (Fig N)