Lukas traversing system - Manual (Page 34)

34
9.3.4 Replacing the handles on traversing cylinder
Any damaged or broken handles must be replaced.
Procedure for fi xing directly on the traversing cylinder:
1. Release the screws on the handle and remove them, together with the washers
underneath.
2. You can now remove the handle and replace it.
3. Assembly is in the reverse order.
Procedure for fi xing with clamps:
1. Release the screws and nuts and remove them.
2. You can now remove the handle and the associated washers from the traversing cylinder
and replace them. If there is damage to the clamps remove them towards the cylinder
head. Make sure not to damage the hoses
3. Assembly is in the reverse order.
Handle
Bolt
Washer
Bolt
Washer
Bolts
Washers
Handle
Nuts
Clamps