Lukas traversing system - Manual (Page 25)

25
Commissioning:
CAUTION / ATTENTION!
Secure the vehicle to be rerailed in accordance with the regulations to prevent its
rolling away, slipping and tipping over!
Set up all the components to be used as described in the Chapter "Setting up the LUKAS
traversing system". When setting up you must comply with all the applicable standards,
guidelines, regulations and statutes!
The separate hydraulic supply and the control of the LUKAS traversing system must be
outside the danger area!
Then connect all the hydraulic components as described in the Chapter "Connecting the
hydraulic equipment".
Bleeding the traversing cylinder:
Before commissioning and following repairs, the equipment must be deaerated.
-
Connect the equipment to the hydraulic pump (see chapter “Connecting the equipment”).
- Fully extend and retract the device several times without load.
NOTE:
We recommend that during the bleeding, the attached unit for the hydraulic
supply should stand at a higher level than the cylinder.
The connections on the hydraulic cylinder should face upwards.
6.2 Start-up
ATTENTION!
During commissioning you must observe all the instructions and regulations from
the separate operating instructions for all the components that you use in the
rerailing system that is to be commissioned!
Work required before commissioning:
Before commissioning you must carry out a visual check for damage and leaks on all
components being used. Damaged components must not be used and must be replaced!
The hydraulic components must be bled to remove air before commissioning!