Apple Ethernet CS Twisted-Pair Card - Manual (Page 4)

About this communications card
The Apple Ethernet CS Twisted-Pair Card expands the
communications capabilities of models of Macintosh
computers that have a communications slot (CS). The card
is designed for an Ethernet network that uses IEEE
10BASE-T standard twisted-pair cable. To connect to an
Ethernet network, you must also install EtherTalk software,
which is included with the Twisted-Pair Card. After you’ve
added the card and installed EtherTalk software, you
connect to your network by attaching a network cable to
the card’s RJ-45 port and to a network controller unit (hub).
The Apple Ethernet CS Twisted-Pair Card works only
with Macintosh System 7 or later. For best performance
your system should have at least 4 megabytes (MB) of
random-access memory.
What’s in the box
■ One Apple Ethernet CS Twisted-Pair Card
Note: Keep the card inside its antistatic bag in
the protective cardboard box until you’re ready
to install it.
■ One floppy disk containing EtherTalk software
■ Warranty card
■ User’s guide
Note: You’ll need to obtain twisted-pair network
cable separately.
WARNING To avoid damage to the card and to
your other computer equipment, be sure that
you’ve turned off power to the computer before
beginning installation procedures.
2