beautypg.com

Troubleshooting guide – Black & Decker FIRESTORM FS210LS User Manual

Page 27

background image

27

BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBLE!
SAW WILL NOT START

WHAT’S WRONG?

WHAT TO DO…

1.Saw not plugged in.

1.Plug in saw.

2.Fuse blown or circuit breaker tripped. 2.Replace fuse or reset

circuit breaker.

3.Cord damaged.

3.Have cord replaced by
authorized service center.

4.Brushes worn out.

4.Have brushes replaced
by authorized service center.

TROUBLE! SAW MAKES UNSATISFACTORY CUTS

WHAT’S WRONG?

WHAT TO DO…

1.Dull blade.

1.Replace blade.

2.Blade mounted backwards.

2.Turn blade around.

3.Gum or pitch on blade.

3.Remove blade and
clean with turpentine.

4.Incorrect blade for work being done.

4.Change the blade.

TROUBLE! BLADE DOES NOT COME UP TO SPEED

WHAT’S WRONG?

WHAT TO DO…

1.Extension cord too light or too long.

1.Replace with adequate
size cord.

2.Low house current.

2.Contact your electric
company.

TROUBLE! MACHINE VIBRATES EXCESSIVELY

WHAT’S WRONG?

WHAT TO DO…

1.Stand on uneven floor.

1.Reposition on flat level
surface.

2.Damaged saw blade.

2.Replace blade.

TROUBLE! DOES NOT MAKE ACCURATE MITER CUTS

WHAT’S WRONG?

WHAT TO DO…

1.Miter scale not adjusted correctly.

1.Check and adjust.

2.Blade is not square to fence.

2.Check and adjust.

3.Blade is not perpendicular to table.

3.Check and adjust fence.

4.Workpiece moving.

4.Clamp workpiece to
fence or glue 120 grit
sandpaper to fence with
rubber cement.

TROUBLE! MATERIAL PINCHES BLADE

WHAT’S WRONG?

WHAT TO DO…

1.Cutting bowed material.

1. Position bowed material
with concave or hollow side down.

2.Rip fence not parallel to blade.

2. Realign rip fence.

TROUBLE! CANNOT LOCK BLADE INTO BEVEL POSITION

WHAT’S WRONG?

WHAT TO DO…

1.Blade tilting lock handle too loose.

1.Remove blade raising and lowering with
handwheel.
2. Remove flat head screw from lock handle.
3. Tighten blade tilting lock handle. The lock
handle (A) is spring-loaded and can be
repositioned by pulling out on the handle (A)
and repositioning it on the serrated stud
located underneath the handle. NOTE: After
tightening, place the handle at the one o’clock
position.
4. Replace the flat head screw.

TROUBLESHOOTING GUIDE