Black & Decker FIRESTORM FS210LS - Manual (Page 16)

16
RIP FENCE
1. Thread the M8x1.25 hex nut (A) Fig. 26,
approximately halfway on the stud of the handle (B).
2. Thread the handle (B) Fig. 26 into the tapped hole
(C) in the fence cam (D). Tighten the hex nut (A) Fig. 26
against the cam (D).
3. Lower rip fence onto table as shown in Fig. 27,
making certain rear clamp hooks over back edge of
table.
4. The rip fence is usually operated on the right hand
side of the saw table. Lift lock handle (B), and position
fence on table. Push downward on handle (B), to lock
fence in place on saw table.
MITER GAGE
The miter gage is shipped completely assembled and is
supplied with a T-slot miter gage bar (A) Fig. 28, that is
inserted into either one of the two T-slotted miter gage
grooves located in the table top, as shown. The T-slot
miter gage prevents the miter gage from falling when it
is extended out beyond the front of the table when
cross-cutting extra wide workpieces.
Fig. 26
Fig. 27
Fig. 28
A
B
B
A
C D