Black & Decker FIRESTORM FS210LS User Manual

Page 14

7. Assemble splitter (H) Fig. 19, to splitter support
bracket (B) as shown using M6x1x20mm hex head
screw (L), 1/4 in. external tooth washer, and 1/4 in. flat
washer.

8. Fasten splitter (H) Fig. 20, to splitter support bracket
using 1/4 in. flat washer, 1/4 in. external tooth
lockwasher and M6 wing nut (M). NOTE: Before
tightening wing nut (M) make certain there is at least a
1/8 in. gap between the bottom edge of splitter (N) and
top surface of table (P) and that protrusion “pins” (K) Fig.
20, are inside the slot of splitter assembly (H).

9. Using a straight edge, check to see if the splitter (H)
Fig. 21, is aligned with the saw blade (R). If an
adjustment is necessary, the splitter (H) can be moved
left or right and rotated.

10. When you are certain the splitter is properly aligned
with the saw blade, tighten the two screws (C) Fig. 22,
that fasten the splitter support bracket to the splitter
bracket and tighten screw (G) that fastens the splitter
bracket to the pivot rod.

Fig. 19

Fig. 20

Fig. 21

Fig. 22