Black & Decker FIRESTORM FS210LS - Manual (Page 11)

11
STAND ASSEMBLY
1. The stand legs have protrusions which align with the
holes in the top and bottom brackets. Assemble the
stand as shown in Fig. 9A, using 16 carriage bolts and
hex lock nuts. Do not completely tighten the hardware at
this time.
A-Top front bracket (with logo)
B-Top rear bracket
C-Bottom side brackets
D-Bottom front and rear brackets
E-Top side brackets
F-Foot
IMPORTANT: THE TOP, FRONT, AND REAR
BRACKETS (A&B) FIG. 9A, ARE LONGER THAN THE
TOP SIDE BRACKETS (E) FIG. 9A. THE BOTTOM
FRONT AND REAR BRACKETS (D) FIG. 9A, ARE
LONGER THAN THE BOTTOM SIDE BRACKETS (C).
2. Assemble the rubber feet (F) Fig. 9A. NOTE: Each
rubber foot is provided with holes for mounting the
stand to the floor surface if required.
ATTACHING DUST BAG
1. Attach the dust bag to the bag frame and place the
frame of the dust bag inside the saw stand as shown in
Fig. 9B. Refer to the section below to attach this
assembly to the saw.
SAW TO STAND
1. Turn saw table face down on a piece of cardboard to
protect the table surface. Place stand upside down onto
saw and align the four holes in the stand with the
mounting holes in the saw.
2. Using the 2 longer screws for the front, place a M8 flat
washer on a M8X1.25X45mm hex head screw. Insert the
hex head screw through the mounting hole in the saw
and the mounting hole in the stand. Place another M8
flat washer on the hex screw and thread a M8X1.25 hex
nut on the screw and loosely tighten. Repeat this
process to complete another hole in the saw front.
Using the 2 shorter screws for the back, place a M8 flat
washer on a M8X1.25X30mm hex head screw in the
back of saw. Insert the hex head screw through the
mounting hole in the saw and the mounting hole in the
stand. Place another M8 flat washer on the hex screw
and thread a M8X1.25 hex nut on the screw and loosely
tighten. Repeat this process to complete another hole in
the saw back.
3. Then, turn saw table face up, as shown in Fig. 9C
(Saw is shown fully assembled here).
4. Push down on top of the saw so the legs of the stand
adjust to the surface of the floor and tighten all stand
hardware and hardware which secures saw to stand.
Fig. 9A
Fig. 9C
Fig. 9B
C
E
B
D E
A C
D
F