Black & Decker FIRESTORM FS210LS - Manual (Page 25)

25
Fig. 56
Fig. 57
D
E
2. Attach the dado head set (D) Fig. 56, to the saw arbor.
NOTE: THE OUTSIDE ARBOR FLANGE CAN NOT BE
USED WITH THE DADO HEAD SET, TIGHTEN THE
ARBOR NUT AGAINST THE DADO HEAD SET BODY.
DO NOT LOSE THE OUTSIDE ARBOR FLANGE. IT
WILL BE NEEDED WHEN REATTACHING A BLADE TO
THE ARBOR.
THE ACCESSORY DADO HEAD SET
TABLE INSERT (E) FIG. 56, MUST BE
USED IN PLACE OF THE STANDARD TABLE INSERT.
THE BLADE GUARD AND SPLITTER
ASSEMBLY CANNOT BE USED WHEN
DADOING AND MUST BE REMOVED OR SWUNG TO
THE REAR OF THE SAW. AUXILIARY JIGS,
FIXTURES, PUSH STICKS AND FEATHER BOARDS
CAN AND SHOULD BE USED.
3. Fig. 57, shows a typical dado operation using the miter
gage as a guide.
NEVER USE THE DADO HEAD IN A
BEVEL POSITION.
ALWAYS INSTALL BLADE GUARD
AFTER OPERATION IS COMPLETED.