Apple Macintosh Performa 6400 Series - Manual (Page 104)

Repairing a damaged disk
If you see a message reporting that a disk is damaged or unreadable, you may
need to repair the disk.
Try these suggestions first
If you can’t start up from a hard disk or you don’t see the hard disk icon on the
desktop, try the following:
m If the hard disk is internal, shut down your Macintosh, wait at least
10 seconds, and then turn it on again.
m If the hard disk is external, make sure that it is turned on and that its cable
is connected firmly; then restart the Macintosh.
m If the hard disk is your startup disk, start up with a different startup disk.
(See the previous section, “Starting Up From the Macintosh Performa CD:
Performa Software.”)
If, after you start up from a different disk, your hard disk’s icon appears on
your desktop, reinstall system software on the hard disk. (See Chapter 7,
“Reinstalling Your Computer’s Software.”)
m Check the ID numbers of all SCSI equipment (anything connected to
the SCSI port [g]) on your computer. Each device must have a unique
ID number. The computer itself (the main logic board inside it) has
the ID number 7 and the internal CD-ROM drive has the ID number 3.
The ID numbers 0, 1, 2, 4, 5, and 6 are available for additional SCSI
devices.
Also check that the chain of devices is terminated properly. For
information on setting SCSI ID numbers and terminating a SCSI chain,
see both the manuals that came with your SCSI equipment and Chapter 3
of this manual.
m If none of these suggestions solves the problem, test the disk by following
the instructions given in “Checking for Damage on Your Hard Disk,” later
in this section.
104 Chapter 6