2GIG CT100 User Manual

Page 12

Congratulations, you have successfully installed your unit. Please proceed to
the OPERATING Guide to initialize the CT100.

IMPORTANT:

If you have labeled and connected your wires

and followed the correct HVAC setup, and your system still does

not operate, contact technical support.
STATEMENT OF USE: This thermostat can be used with

4AA batteries, 24VAC (C wire), 24VAC adapter, heating

and cooling systems and also millivolt heating. It cannot

be used with line voltage systems. This thermostat

is digital and your desired heat or cool temperatures

can easily be set on the large touch screen with the

+/- buttons. A minimum 4 minute off time protects the

compressor from damage.

This thermostat runs on 4AA batteries. The CT100 can be

externally powered with a power source rated from 12V

to 24V, AC or DC, at 100ma or greater. If used, connect to the C and RH terminals (no polarity). The

24VAC “C” wire is the other side of the 24VAC heating transformer and can be found where the other

thermostat wires connect at the wall or at the furnace. Do not use the common or ground side of the

line voltage.

MENU

MODE

LINK

RADIO

TARGET TEMP

HEAT

AUTO