Class1 106759 - ITL 4LT with 1-wire COM 106296 106299 User Manual
Page 11
Intelli-Tank Manual (106759)071006
– 11 –
Class 1
The calibration process can be cancelled at any time by activating the LEFT
magnetic switch.
1 Point Calibration
1 point calibration only calibrates the full point. The empty calibration is always
set to 0.55V (approximately 1.5 inches of liquid).
1. Make certain that the tank is FULL.
2. Enter the password RLLR LRRL. The unit will respond by flashing the top
LED twice. The unit will then revert to normal operation by displaying
FULL (all LEDs on).
2 Point Calibration
3. Enter the password RLLR LLRL. The unit will respond by flashing the two
center LEDs twice. The unit will then begin cascading the LEDs from top
to bottom (drip).
4. Make certain that the tank is EMPTY and then activate the RIGHT switch
to store that point. The unit will flash the top LED and then turn on all four
LEDs.
5. Fill the tank and then activate the RIGHT switch. The unit will respond by
flashing the top LED then lighting the two center LEDs and then reverting
to normal operation by displaying FULL (all LEDs on).
5 Point Calibration
1. Enter the password RLLR LRLR. The unit will respond by flashing the
two center LEDs five times. The unit will then begin cascading the LEDs
from top to bottom (drip).
2. Make certain that the tank is EMPTY and then activate the RIGHT switch
to store that point. The unit will flash the top LED and then turn on the
bottom LED.
3. Fill the tank to the one-quarter tank point and then activate the RIGHT
switch. The unit will flash the top LED and then turn on the bottom two
LEDs.
4. Fill the tank to the one-half tank point and then activate the RIGHT switch.
The unit will flash the top LED and then turn on the bottom three LEDs.
5. Fill the tank to the three-quarter tank point and then activate the RIGHT
switch. The unit will flash the top LED and then turn on all four LEDs.
6. Fill the tank to the full point and then activate the RIGHT switch. The unit
will respond by flashing the top LED then lighting the two center LEDs and
then reverting to normal operation by displaying FULL (all LEDs on).