AEM 30-8760 CAS Trigger Disc - Manual (Page 3)

Page 3 of 9
Instructions with photos on the following pages:
Remove the MAF sensor assembly as shown in figure 1. The arrow points to a mount that
may or may not be present on your vehicle which was removed using a 10mm
combination wrench and 10mm socket. The hose clamp is removed with the ¼” flat
screwdriver.
Figure 1: MAF assembly removal
Figure 2 shows the location of the CAS sensor (inside the distributor assembly).
Figure 2: Location of CAS sensor (underneath distributor cap)